Relay Kit for 20 AMP DPST made by Pentair RLYLX
Application:
A 20 Amp DPST Relay used to activate 230V or 115VAC equipment (pumps, lights, etc.) from auxiliary control circuits on Pentair Pool ProductsControl Systems.
Specifications:
| TYPE | DPST |
| MAX AMPS | 20 |
| PUMP HP MAX | 2 |
| LIGHTS MAX | 1000 WATTS, 500 PER POLE |
| CONNECTOR BLOCK | EACH SCREW ACCEPTS TWO 12-GAUGE WIRES |
Installation:
- Remove cover panel from right-side compartment of Power Center to expose high voltage section.
- Remove wingnut from mounting stud of Relay Kit, and position relay below existing relays.
- Loosen LOCK SCREW of hinged faceplate (left-side compartment), and swing it open to expose low voltage section. Feed low voltage connector through lower hole, and mounting stud through upper hole in compartment divider.
- Plug low voltage connector into appropriate relay socket on circuit board, located behind hinged faceplate.
- Snap terminal block into appropriate position on mounting track in high voltage section. Push hard to secure.
- Make appropriate LINE and LOAD connections to terminal block.
Reviews
There are no reviews yet.