CVDB050 ClearView Shimmer-N Shock Stabilized Granular Chlorine Di-Chlor DiChlor 50 Lbs.

ClearView Swimming Pool and Spa  Shimmer-N Shock Stabilized Granular Chlorine Di-Chlor DiChlor 50 Lbs. CVDB050

Chlorine-based shock treatment to control bacteria and algae.

How to Use ClearView Shimmer-N Shock Stabilized Granular Chlorine Di-Chlor DiChlor 50 Lbs. CVDB050:

Add dosage of this product during evening hours while filter is running. When adding this product to your pool, broadcast the product evenly over a wide area in the deepest part of thepool. Use entire contents when opened. If any granules settle to the bottom of the pool use brush to disperse.Start Up: Before using this product, make sure that the filtration system is clean and operating properly. Adjust the pH of the water to a range of 7.2-7.6 using suitable products and a reliable test kit. Adjust the alkalinity of the water to a minimum of 125 ppm (mg/L), based on the test kit reading. Add a sufficient amount of this product directly to the surface of circulating water to raise the free chlorine level in the water to 5-6 ppm (mg/L), based on the test kit reading. As a guide, for swimming pools addition of 10 ounces of this product for each 10,000 gallons of water will increase the free residual chlorine by 4 ppm (mg/L).Shock Treatment:

• Super chlorination: In extremely hot weather, when many people use the pool, when water becomes hazy or after heavy rains, a shock dosage of chlorine may be obtained by spreading this product over surface pool water. 14 ounces of this product per 10,000 gallons of pool water provides approximately 6 ppm of chlorine. Note: Do not use pool until chlorine residual falls below 4 ppm.
• Maintenance Treatment: Add this product daily or as needed to maintain the free chlorine residual in the water at 1-3 ppm (mg/L) as indicated by a reliable test kit. Each ounce of this product will provide about 0.4 ppm (mg/L) of available chlorine to 10,000 gallons of water. Weather and usage effect sanitizer levels. Maintain the pH at 7.2-7.6 and the alkalinity at a minimum of 125 ppm (mg/L).

As a guide for swimming pools, addition of five ounces of this product for each 10,000 gallons of water will increase the free residual chlorine by 2 ppm (mg/L).Description

• Active Ingredient:  99% Sodium Dichlor
• No pre-dissolving
• Completely soluble
• No residue
• Will not cause pH bounce
• Economical shock treatment
• Restores sparkle and clarity to dull water
• Perfect for vinyl-lined or above ground pools
• Shock/shocks

SDS – Safety Data Sheet